So it turns out the PS4 does have software authentication...

[DonFerrari]

wilco said:

DonFerrari said:

wilco said:

DonFerrari said:
And I gave you a option that you just said you wouldn't do... make your X360 controler work on PS4 by using the insides of it on the X360 shell.

You can't be serious about that. That will NOT work.

Why wouldn't a controller made of the shell of a x360 controller but the internals of PS4 controller work? I actually don't believe you are serious. Have you noticed the only people that supported you are know sony haters? That just want to say ms controllers are better and even most of them would Just say buy the superior console as well?

So, to explain this to you I'll give you an assignment. Go get a square peg, then get a round hole with a radius less than the width of the square peg, now try to fit the square peg into the round hole. After you attempt this you will understand why your suggestion won't work.

Aan engineer I would either choose peg and hole compatible if I was designing it. If I was solving the problem I would retify the hole to a square.

But it seems you want to fit the square peg on the round hole (and even if the diameter were compatible to the side it wouldn't fit, it would just enter it), since you want to use an incompatible controller on a system and want Sony to solve your problem. As you said you are just entitled gamer.

I'm pretty certain there are a lot of capable people who could mod the two controllers to make what I said happen, but you seem to Just want to complain, this is why I asked you to prove impossible and you just was condecending and patronizing, not good argumentation skills.

Also you ignored the second part because the answer doesn't help you.

So please answer technically why can't you use the mold of a x360 with the board of a ps4... As that is exactly what the 3rd party controller posted to you was in the end.